How to Fit the EzyDog Convert Harness

The Convert Harness offers an adjustable, no-pull fit with a lift handle for control. Follow these steps to fit it correctly:

1. Open the Harness: Untuck the straps from the grab handle. There will be two straps with buckles that are intended to go under the dog and a reflective strap affixed to itself with hook and loop closure.

2. Configure the front strap: Undo the velcro from the reflective strap and pull it apart completely. Locate the oblong steel D-ring on the opposite end of the harness and feed the velcro strap through it, then reapply the velcro.

3. Slide Over the Head: Lift the harness over your dog's head and settle the neck/chest section onto their chest and shoulders.

4. Connect the Girth Strap: Bring the girth strap underneath your dog's belly and clip it into the buckle on the opposite side until it snaps securely. Adjust using the sliding triglide as needed.

5. Check the Fit: Slide a hand underneath the straps to confirm the harness sits snug against the body without being too tight.

6. Use the Magnetic Handle: Use the sturdy handle on top of the harness to lift or guide your dog when extra control is needed.